MICROCEMENT PROTECTOR DECO SATIN

- Environmental conditions:

         - It is recommended, especially indoors, that there be air renewal.
         - Room temperature: 5-35 ºC - RH ? 75%.
         - Substrate temperature: ? 7ºC and 3ºC above the dew point.
        
- Preparation of the mixture:

         - By manual or slow mechanical agitation, homogenize the MICROCEMENT PROTECTOR DECO
         - Add the amount of water depending on the application method and the surface to be varnished.
         - Control the speed to prevent the mixture from acquiring excess air.

- Dilution:

         - For walls and roller application, a maximum of 10% water.
           If the application is by spray, an additional 5% can be added.
         - For floors and roller application, it is possible to increase the dilution a further 5%.
           If the application is by spray, an additional 5% can be added.
         - Distilled water in all cases.

- Application conditions:
        
         - Wait at least 4 hours, and no more than 24 hours, from the application of the last coat of MICROCEMENT SEALER,            to start varnishing with MICROCEMENT PROTECTOR DECO.
         - The recommended thickness per layer will be between 40-50 dry microns.
         - In all applications, make sure that you do not leave more than 110 g/m2 of product.
         - 2 layers. For greater resistances a third can be given.
      
- End use:

         - The varnished surface acquires its maximum physical resistance after 21 days (at a temperature of 20 ºC).
         - The Microcement Ó deco System is not recommended for liquid containment supports, such as swimming pools, tanks            or bathtubs.
         - The Microcement Ó deco System finished with MICROCEMENT PROTECTOR DECO (1K) is ideal for undemanding uses            on vertical surfaces of walls, furniture, etc.
         - For use in humid environments and/or on demanding horizontal surfaces, use MICROCEMENT PROTECTOR (2K).

MICROCEMENT Ó deco:

1. On dry MICROCEMENT SEALER.
2. Check that the appearance of the surface is as desired.
3. Check that the surface of the support is clean, dry and free of any contaminant.
4. Apply two coats of MICROCEMENT PROTECTOR DECO, respecting the drying times.