MICROCEMENT WALLS

- Environmental conditions:

     - It is recommended, especially indoors, that there be air renewal.
     - Ambient temperature: 5-35 ºC - RH ? 75%.
     - This range must be maintained during the first 72 hours.
     - Substrate temperature ? 8ºC and 3ºC above the dew point. Essential to avoid condensation.
     - Variations in ambient temperature during the application process also alter the setting and drying times of the material. Below 20ºC, the drying time increases.

- Preparation of the mixture:

     - In the empty bucket that is included in the pack, pour the MICROCEMENT RESIN with color and previously shaken. The        proportion is 12 Kg Part A (Powder) + 5 Kg Part B (Resin with color).
     - Sprinkle little by little and beat by mechanical stirring until obtaining a homogeneous paste free of lumps.

-Application conditions:

     - Apply with a steel trowel with rounded edges, in thin layers, 2 to 3 layers depending on the application, leaving 2 to 3 hours between coats, until the desired decorative effect is achieved.
     - Consumption calculated on MICROCEMENT BASE:
               - Per coat: 0.5 Kg / m2 (approx 0.2 mm thick). (12 A + 5 B for 20 m2)
               - Total: 1-1.5 Kg / m2 (0.8 - 1 mm thick). (12A + 5 B for 6 - 12 m2)
     - Maximum thickness of the entire BASE + WALLS system (1 to 3 mm)

- End use:

     - After 24 hours, sand the entire surface well, with a fine sandpaper with a grain greater than 220.
     - We perfectly clean the dust generated, vacuuming.
     - Optimal mechanical properties are reached after 28 days.
     - The MICROCEMENT ODeco system is not recommended for liquid containment supports, such as swimming pools, tanks or bathtubs.

On MicroCement Base:

- Sand with 120/180 clean and remove dust well, preferably by vacuuming.

On construction supports with good planimetry:

- Use the appropriate MICROCEMENT PRIMER ABS Ó N-ABS in each case.
- Follow instructions for preparing the support in its technical sheets.