RASATO VIVOS

- Homogenize the product slowly using a spatula.
- Dilute with water in the prescribed proportion.
- As a base coat, apply OVALDINE MATE BLANCO.
- Apply to well-adhered backgrounds.
- The support must be perfectly sealed and uniform, something that is usually done in one hand.
- In exceptional cases of high absorption, apply two coats.
- Apply the background of the desired color depending on the aesthetic effect you want to obtain.
- The 31 colors of the RASATO VIVOS card (C00762) can be obtained with Colormont and Base TR.
- Recommended methods of use:
  1.
- Glove or natural sponge: Lightly impregnate the glove with Velato and apply to the base surface with rotating movements. With short-hair gloves the finishes are less accentuated than with long-hair gloves. It is also possible to spread the product evenly with a wool roller and then pass the glove over the applied area.
   2.
- Special suede roller: It is usually spread with a smooth wool roller on a limited surface, depending on the number of applications and the weather, proceeding before drying with the special roller.
   3.
- Tubular or textile tampon: Apply the Velato on small surfaces with a wool roller and then with the moistened tampon or by impregnating the tampon directly into the Velato. To achieve the effect, tap it gently with the chosen pad intermittently, making sure that no smooth areas remain.
   4.
- Brush: Extend the Rasato in neighborhoods or brush strokes, creating different effects depending on the size of the brush and the sweeping procedure.
   5.
- Airbrush: Direct air gun and preferably gravity with a 2.
5 mm diameter nozzle with air regulator. Apply at a distance of 60/80 cm. of the wall applying first horizontally and then vertically.    A multi-coloured finish can be achieved by applying a second coat wet on wet.
   6.
- Spatula: Special spatula, preferably made of plastic or stainless steel.

Do not wash until after 30 days.

Cement mortar:

-Wait until completely set (30 days minimum).
-Clean the support of possible efflorescence using an abrasive blast, as well as neutralize alkaline surfaces.
-On excessively polished surfaces, sand to open the pore.
-Fix the removable supports with a suitable fixative (See family 6).
-Clean the support of foreign products and/or residues.
- Putty the defects of the support with plaster (Plasmont Exteriors) (see the PREPARATION OF BACKGROUNDS family for the lines corresponding to powder plasters and prepared putties to make an appropriate choice).

Plaster:

-Wait until it is very dry (max.
20% humidity).
-Remove foreign products and/or waste from the support.
-Eliminate efflorescence.
-Regulate surface absorption using sealing primer or matte paste.
-On excessively polished surfaces, sand to open the pore.
-Fix loose or floury supports using a suitable fixative (See family 6).
- Putty with plaster to eliminate defects in the support (see in the PREPARATION OF BACKGROUNDS family the lines corresponding to powder plasters and prepared putties to make an appropriate choice).
-Treat moldy supports with Monto Limpia Moho.