KORAZA TOP COVER

- Shake the product until evenly mixed.
- Do not apply the product at temperatures below 5ºC and not above 35ºC.
- Do not apply with risk of imminent rain.
- The substrate must be completely dry.
- The substrate temperature must be above 5ºC to avoid freezing and below 40ºC to avoid defects in the application.

Minimum recommended consumption (allow to dry for 24 hours between coats):
1. 1st coat of 0.
50 l/m2 + incorporate fibreglass mesh (must be properly impregnated)
2. 2nd coat of 0.
50 l/m2
3. 3rd coat of 0.
50 l/m2 (the fibreglass mesh must be completely submerged)

For warranty coverage, it is necessary to apply 1.
5 L/m² and install a fibreglass mesh (check conditions).

Cement mortar:
1. Wait until fully set (at least 30 days).
2. Clean the surface of any foreign substances, residues and poorly adhered product. Treat mouldy substrates with Monto Limpia Moho.
3. Use abrasive blasting to prevent efflorescence and neutralise alkaline surfaces. On very smooth surfaces, key lightly with sandpaper. Putty with Plasmont Fibra Elástico if necessary.
4. The substrate must be completely dry before preparation. The humidity value measured with a hygrometer must be less than 4%.
5. Apply Fijamont over the entire cement mortar surface to completely seal the substrate and prevent it from coming into contact with the Koraza Top Cover.
6. It is recommended to prime with Koraza Primer for optimum adhesion of the system and to facilitate the incorporation of the fibreglass mesh. Leave to dry for 4-6 hours.

Catalan tile or matt porous brick:
1. As for cement mortars - application of Fijamont fixative is not required.

Polyurethane foam:
1. As for cement mortars - application of Fijamont fixative is not required.

Asphalt covering:
1. As for cement mortars, application of Fijamont fixative or Koraza Primer is not required.
2. Check adhesion. We recommend that you prime with Imprimación Epoxi Suelos.