PLASMONT ANTIHUMEDAD
applications
- Natural stone
- Indoors/Outdoors
- Brick
- Concrete block.
- Undamaged rough mortar coats.
- Brick or natural stone walls affected by rising damp
How to apply?
- Stainless trowel
Colors
- In the case of exterior use do not apply in conditions with strong winds, rains or frosts.
- In case of high temperatures or strong winds, moisten the mortar plaster with water spray during the 24 hours following its usage.
- Do not apply on plaster, old paint or surfaces that disintegrate easily - sanitise if necessary.
- Do not use for concrete repair.
- Do not add sand, cement or any other product that modifies the original formulation.
- Always mix the product with the indicated amount of water (23-25%).
- Mix together until totally homogeneous with a mortar mixer low revolutions or with a spraying machine.
- After mixing, do not add additional water if the product dries out in the kneading bowl.
- Apply the mortar in a compact and uniform way. Even out the surface.
- Then trowel with a wooden trowel without exerting too much pressure so as not to seal the surface of the mortar.
- It is recommended to leave a minimum of two layers of 20 mm thickness each.
- Once hardened, it should be finished with a suitable coating. The best results are obtained with Ovaldine Siloxane/Silicato, other types of coatings can also be applied such as Nevada Siloxane, Tixoway antihumedad, Ovaldine Montolite...
- Do not cover with materials that act as vapour barriers: acrylic paints, natural stone or ceramic tiles.
- In joints between different types of brackets use fibreglass mesh as reinforcement.
- Product residues are easily removed with water before the product hardens.
- Avoid breathing the product?s dust and avoid contact with skin and eyes. For further information, please refer to the material safety data sheet.
- Dry usage (1cm layer): 10 Kg/m2 (It is recommended to leave a minimum of two layers of 20 mm thick each).
- Thickness: minimum 5mm - maximum 30mm.
- If the surface is contaminated with micro-organisms (algae, fungi, etc.
), clean the surface using Monto Limpia Moho or with water and bleach. Rinse to remove debris caused by the cleaning product.
- Wash the surface with clean water to eliminate efflorescence and soluble salts that could hinder adherence - wait for the water that was used when cleaning to evaporate.
Certifications
Downloads
I´m interested in this product
I´m interested in this product
Confirm the product and your contact information to be able to inform you and advise you in a personalized way.
Readily available stock
Gestión automatizada de las ubicaciones y las existencias de los productos.
Perfect orders
Los pedidos son preparados mediante radiofrecuencia reduciendo los errores en su preparación a 0.
Warehouse management
Ubicación automática de los productos en el almacén mediantes transelevador.
Fast loading
8 loading docks for 24-ton trucks.
Our own transport
Flota propia de camiones de reparto preparados para transporte ADR.
We are always close by
Cadena de tiendas propia y suministro a puntos de venta en toda España.
liter calculator
Para pintar m2 de superficie con mano(s) de pintura necesitas:
de PLASMONT ANTIHUMEDAD