Chalk effect paint, velvety appearance and fast drying. To create vintage or aged effects, using the application technique (abrading by sanding).

Shake product until perfectly homogenized.
First coat should be dilluted depending on surface conditon and porosity level.
Finish with one or more coats slighlty dilluted until surface is totally covered.
Do not apply product at temperatures below 5º C, above 35 °C, or any surfaces which have been exposed to sunshine.

Cement morter:
- Wait till complete drying of product (30 days minimum).
- Remove off any efflorescences by abrasive jet
- Neutralize alkaline surfaces.
- Extremely polished surfaces should be sanpapered to open pores.
- Remove off any foreing products or remains.
- Bad condition surfaces should be anchored properly (see family 6).
- Cover surface imperfections with Plastmont (See Family 6 to help you choose the most suitable product to prepare surfaces).

Plaster:
- Wait till complete drying of product (20% max. Moisture level).
- Remove off any foreign product or product remains.
- Remove off any efflorescences.
- Use a sealant or matt paste to regulate surface absorption.
- Extremely polished surfaces should be sandpapered to open pore.
- Very damaged surfaces should be fixed with suitable product (See Family 6.
)
- Cover surface imperfections with plaster or putty (See Family 6 to help you choose the most suitable product to prepare surfaces).

Gypsum Board:
This product can be used as primer diluted to 50% in water.