Aliphatic varnish highly resistant to impact and abrasion. Elastic. Does not yellow. Crystalline texture.

-Mix both products Acripol Barniz + Catalizador and stir them until perfectly homogenized.
-Mixture should be obtained by pouring Catalizador (catalyst) over base (Acripol Barniz) (varnish) within given proportions.
-When pore is open, apply the priming products shown in table below.
-New wood should be previously primed with Montoxyl Fondo (ref. 1301) to prevent surface from fungus and harmul bacteries.
-Keep room well ventilated while product is drying.
-Do not apply when moisture contents it over 80%.
-Test adherence level on tiled and ceramic surfaces. We recommend applying hydrochloric acid for pore opening.
-Test adherence level on difficult areas. If anchoring is poor, proceed to prime as indicated in table below.
-The previously stated performance information refers to the CA+CB mix

Iron and by-products:
- For surface protection prior to decoration, apply a suitable primer (see family 9) following its corresponding data sheet guidelines.
-Prior to decoration, surface should be free of any foreign products, grease, dust and completely dry. Should it show any rust, apply our Oxifin or remove it by brushing it off or any other mechanical system.
Construction (plaster, cement and by-products):
-Remove off any efflorescences and neutralize alkaline surfaces.
-Remove off any foreign product or remains.
-Once dry, prime with Fijamont, Ecoprimer or Pasta Mate Industrial.
New wood:
-Surface should be free of any foreign products or remains.
-Apply on wood with less than 20% moisture content.
-Apply on wood in good condition, dry and free of grease and dust.
-Sandpaper and eliminate any remains in joints and mechanical faults.
-Old wood should be previously sandpapered and primed. Remove any dust by brushing it off or using any other mechanical system.
-We recommend priming with Montopol Fondo MS-1 or Montopol Fondo Blanco MS-5.