BARNIZ ACRIPOL MATE

-Mix both products Acripol Barniz + Catalizador and stir them until perfectly homogenized.
-Mixture should be obtained by pouring Catalizador (catalyst) over base (Acripol Barniz) (varnish) within given proportions.
- Do not apply with relative humidity above 80%, or at temperatures below 5ºC.
-Do not apply the product at high temperatures, or on surfaces exposed to strong sunlight.
-Keep room well ventilated while product is drying.
- Given the wide spectrum of supports in direct applications on difficult-to-adhere surfaces, it is convenient to carry out technical adhesion tests.
-When pore is open, apply the priming products shown in table below.
-The previously stated performance information refers to the CA+CB mix

Iron and by-products:
- For surface protection prior to decoration, apply a suitable primer (see family 6) following its corresponding data sheet guidelines.
-Prior to decoration, surface should be free of any foreign products, grease, dust and completely dry. Should it show any rust, apply our Oxifin or remove it by brushing it off or any other mechanical system.

New wood:
-Surface should be free of any foreign products or remains.
-Apply on wood with less than 20% moisture content.
-Apply on wood in good condition, dry and free of grease and dust.
-Sandpaper and eliminate any remains in joints and mechanical faults.
-Old wood should be previously sandpapered and primed. Remove any dust by brushing it off or using any other mechanical system.
-We recommend priming with GAMA MONTOPOL FONDO.

Construction (plaster, cement and by-products):
-Remove off any efflorescences and neutralize alkaline surfaces.
-Remove off any foreign product or remains.
-Once dry, prime with with the same diluted product.