FERRORITE ACQUA LISO

- Remove the product until its perfect homogenization.
- Apply on clean and dry substrata, eliminating the dirt by means of desengrasantes or detergents and clean water.
- Apply following the norms marked in the attached picture of application.
- Not apply the product to high temperatures nor on exposed surfaces to strong insolation.
- Not apply with relative humidities superior to 80%.
- In light metals and galvanized  take out perfectly the grease and Verify adhesion.
- Apply 2 coats, the one of them in vertical sense and other in horizontal to compensate irregularities in the support or possible defects derived from a defective application, assuring therefore a minimum thickness of primer layer.
- Respect the minimum and maximum intervals between layers.
- Respect recommended the maximum and minimum thicknesses of film taking care of the yield.
- Not apply on supports wet by the low nocturnal temperatures (matinal dew), nor reheated since it can affect the quality short and long term of the product.
- Maximum Time of storage: 24 months from its manufacture in its perfectly closed original package, under cover and to temperatures between 5º and 35ºC.
- Consult and to fulfill the NORMS OF FORCED FULFILLMENT MARKED BY the CEE EFFECTIVE LEGISLATION for COMMERCIALIZATION.
- Fulfill the norms marked by indicated the EFFECTIVE LEGISLATION OF the EEC in the package.
- Given to the great variety of plastic supports and alloys (galvanized, covered with lead, zincados?), the accomplishment of a previous  to confirm the correct properties of the product on the support is advisable.

Metallic new supports:

- Eliminate oxide and husks lamination by means .
- Eliminate fats and to take the grease out of.
- Eliminate old painting badly adhered.
- Verify that the support is well dry.

Galvanized and light metals:

- Take out perfectly the grease and verify adhesion.