MONTOSINTETIC FERRUM

-Stir product thoroughly.
-Follow guidelines as shown in table below.
-Only apply on clean and dry surfaces, clean off any dirt by using clean water and detergents.
-New wood should be previously primed with Montoxyl Fondo (ref. 1301) to prevent surface from fungus and harmul bacteries.
-Do not apply product at high temperatures or overheated surfaces exposed to sunshine.
-Keep room well ventilated while product is drying.
-Do not apply when moisture contents it over 80%.

New wood:
1. The base must be free from foreign materials and/or waste matter.
2. Apply to wood with a moisture content of less than 20%.
3. Apply to wood which is healthy, dry and free from grease and dust.
4. Sand down and remove any remnants of glue from the joints and defects from mechanical process.
5. If the wood shows signs of ageing it must first be sanded down, primed and any dust removed using a plane or any other
mechanical device.
6. In this instance the most suitable primer is the Selladora Sellalux.

Iron and its derivatives:
1. To protect the material, prior to decorating, treat with suitable primers (family 6) following the specifications given on the
card.
2. To decorate the material it must be free from foreign materials and/or waste matter and should be dry and free from
grease and dust. If it shows signs of rusting, the rust should be removed using a planing machine or any other mechanical
device. Also suitable for use is Oxifín (see technical record).

Plaster work (plaster/ gypsum, cement and derivatives):
1. Treat these mediums in the usual way, removing saltpetre, excess moisture and efflorescence.
2. Remove foreign materials and/or waste matter.
3. Once dry, prime using Sellalux Primer.