MONTOSINTETIC FERRUM FINO

Stir the product until perfectly blended.
-Apply to clean, dry substrates, removing dirt with degreasing agents or detergents and clean water.
-Apply, following the rules set out in the attached application table.
-Prior to application on new woods, prime with Montoxyl Fondo (code 1301) if you require preventive protection against fungus and bacteria.
-Do not apply the product to extreme temperatures, or to surfaces exposed to strong sunlight.
-Ventilate well during the time that the product is drying.
-Do not apply at relative humidity in excess of 80%.

New woods:
1. The base must be free from foreign products and/or residues.
2. Apply to woods with a moisture content of less than 20%.
3. Apply to healthy, dry wood, well cleaned of dust and grease.
4. Sand and remove any remnants of glue from the joints and faults from the machining.
5. If the wood shows signs of ageing, it should first be sanded down, primed and any dust/powder removed through brushing or any other mechanical means.
6. In this case, the most suitable primer is Selladora Sellalux.

Iron and derivatives:
1. To protect the base, before decorating it, treat it with suitable primers (family 6) following the specifications set out on its technical sheet.
2. In order to decorate the base, it must be free from foreign products and/or residues, and also dry and free from dust and grease. If it shows signs of oxidation, the rust must be removed through brushing or any other mechanical means. Oxifín is also suitable (see technical sheet).

Works (plaster, concrete and derivatives):
1. Treat these bases in the usual way, removing saltpetre, excess moisture and efflorescence.
2. Remove foreign products and/or residues.
3. Once dry, prime with Sellalux Primer.