MONTOSPRAY ACRILICO MATE

Shake the container vigorously for about 2 minutes to homogenise its contents perfectly.
On absorbent surfaces, prime prior to application.
Carry out application tests in a non-visible place.
Protect areas that are not to be painted.
Apply at a distance of 25-30cm from the surface in light, criss-cross strokes.
Do not apply the product at high temperatures, or on surfaces exposed to strong sunlight.
Do not apply while the relative humidity is above 80%.
Do not use at temperatures below 15ºC.
When finished, empty the contents of the cannula by dosing with the container upside down.
Approximate yield per 400ml container 1 - 2 m2 (two cross-coats)

New woods:
-The surface must be free of foreign products and/or residues.
-Apply on wood with a moisture content lower than 12%.
-Apply on healthy wood, well degreased, dust-free and dry.
-Sand and remove possible glue residues on assemblies and machining faults.
-If the wood shows signs of ageing, it must be previously sanded and the dust removed by brushing or any other mechanical means.
-Protect the areas that we do not want to paint.
-Eliminate, in general, products that are poorly adhered or in poor condition.

Iron, derived metals and other metals
-The surface must be free of foreign products and/or residues.
-The surface must be degreased, clean and dry.
-On rusty surfaces, we must eliminate the rust by the usual means recommended by Montó with any rust inhibitor manufactured by our Company, which should be applied in advance.
-We must protect the areas that we do not want to paint.
-Eliminate, in general, products that are poorly adhered or in poor condition

Works (plaster, cement and derivatives, cardboard):
-Eliminate foreign products and/or residues.
-The surface must be degreased, clean and dry.
-Eliminate possible efflorescence using traditional methods.
-Eliminate, in general, products that are poorly adhered or in poor condition.