MONTOXYL LASURE ACQUA SATINADO

1. General Instructions

- Stir the product until completely homogeneous.
- Apply to clean, dry surfaces.
- Sand beforehand to ensure good penetration and even coverage of the wood.
- Applying over Montoxyl Lasur Fondo, after sanding, provides the best finishes and optimal coverage.
- Apply following the dilutions recommended in the Application Systems section.
- Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
- Maintain good ventilation during the drying time.
- Do not apply in relative humidity above 80%.
- Avoid accumulation on the wood surface in all cases.
- Suitable for furniture and vertical surfaces.
- It can be applied without sanding between coats, although light sanding is recommended to ensure perfect adhesion, especially for woods prone to take out sliver.

2. Exterior wood, always colored.

- It is highly recommended to prepare a sample if you wish to see the final color.
- The final color of wood treated with this system will require at least 2 or 3 coats of the product.
- If the final result is too intense, you can request a reduction in the percentage of colorant before preparing the colored products at COLORMONT.

New Wood:

1. The surface must be free of foreign matter and/or residue.
2. Apply to wood with a moisture content of less than 20%.
3. Apply to sound, well-degreased, dust-free, and dry wood.
4. For wood with internal resin stains (usually softwoods) and/or oily tropical woods, it will be necessary to clean them first with solvent.
5. Sand and remove any glue residue from joints and machining imperfections.
6. If the wood shows signs of aging, it must be sanded beforehand, removing dust by brushing or any other mechanical means.