NEVADA SATINADO

- Product should shaken until perfectly homogenized.
- Product should be dilluted depending on surface porosity and condition on first layer.
- Finish with one or more layers slightly dilluted until total surface covering.
- Do not apply product at temperatures under 5ºC or on any surfaces which have been exposed to sunshine.
- Do not wash for the first 24 days.
- Clean tools with water immediately after use.
- Never apply it outdoors if there is an imminent risk of rain, and avoid excessively wet days.
- For spraying with Airless equipment, use 15 to 23 inch nozzles, pressure 150 bar.

Cement morter:
-Wait till complete drying of product (30 days minimum).
-Remove off any efflorescences by abrasive jet and neutralize alkaline surfaces.
-Extremely polished surfaces should be sanpapered to open pores.
-Remove off any foreing products or remains.
-Very damaged surfaces should be fixed with suitable product.
-Use Emulsión Fijadora/Fijamont like primer to prevent ?sheen?.
-Cover surface imperfections with Plastmont Exteriores (See Family 6).

-Plaster:
-Wait till complete drying of product (20% max. moisture level).
-Remove off any foreign product or product remains.
-Remove off any efflorescences.
-Use a sealant or matt paste to regulate surface absorption.
-Extremely polished surfaces should be sandpapered to open pore.
-Very damaged surfaces should be fixed with suitable product (See Family 6).
-Use Emulsión Fijadora/Fijamont like primer to prevent ?sheen?.
-Cover surface imperfections with plaster or putty (See Family 6).

Plasterboard partition walls:
1. Carry out a general sanding of the joints and putty fixing areas.
2. Then, clean them to ensure the substrate is free of dust, grease and other contaminants.
3. For application on coloured boards that tend to generate stains, apply Montoplac Sellador Antimanchas.