ADITIVO ANTIDESLIZANTE

- Stir the product until perfectly blended.
Manually from bottom to top, or slowly using mechanical means.
- Apply on clean and dry substrates.
- Ensure that the wood does not have traces of oil or other foreign substances.
- Sand before application to ensure good penetration and smooth finish on the wood. Sand first with 40-80 grain -  if the result is too uneven, smooth with 150-220 sandpaper.
- Dry wood with a moisture content lower than 20%.
- The first coat should be with Crea impregnante color to ensure optimum slip resistance.
- Dry wood with a moisture content lower than 20%.
- Sand gently if the wood has risen in areas.
- Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
- Ensure the area is well ventilated while the product is drying.
- Do not apply with relative humidity over 80%
- Apply a maximum of 120 g/m2 with each coat. Distribute the non-slip particles evenly.
- Test the characteristics according to the base used to ensure the best slip resistance results.

New wood:
- The base must be free from foreign products and/or residue.
- Apply to woods with a moisture content lower than 20%.
- Apply to healthy, grease-free, dust-free, dry wood.
- Sand down to remove any traces of glue in joints and milling defects.
- If the wood shows signs of aging must be previously sanded and removed by brushing or any other mechanical means.
- Apply a maximum of 120 g/m2 with each coat. Distribute the non-slip particles evenly.