MONTOEPOX S/M

Stir until perfect homogenization both components.
- Stir and mix in the prescribed conditions, leaving the mixture rest for 15 minutes.
- Apply on dry supports, sanitized, and free of foreign bodies.
- On metal: dry film thickness on coatings between 25 and 40 microns.
- Do not apply at temperatures below 5 º C neither to relative humidity above 85%.
- Do not apply at high temperatures, or heated surfaces.
- Humidity of flooring: maximum of 4% measured at a depth of 2cm.

SOIL: Its fundamental its proper preparation.
1. Wait until completely set (at least 30 days): Remove efflorescence.
2. The pavement should be healthy, clean, dry and if necessary screed.
3. Fats and oils should be totaly eliminated.
4. The blasting is the best solution, although in some cases a caustic soda solution 15-20%, followed by rinsing and neutralization is suficient.
The appropiate porosity from the pavement is achieved by blasting.
5. In soils with moderate porosity it might be sufficient a treatment salfumant based chemical followed by extensive rinsing water.
6. In case of doubt before applying a chemical treatment please do not hesitate to speak with our Technical Department.
7.
On asphaltic surfaces prime previously with 'Imprimación epoxi suelos', never apply at high temperatures, eliminate foreign products and check that there is no migration of plasticizers.

METALS: The support must be free of any foreign products and / or debris. It must properly primed, following the guidelines set out in the primer.