PLASMONT AL USO MULTIUSO

- Using the tools indicated in the application system, clean and remove rust.
- Repaint once the indicated time has elapsed. As this depends on humidity, temperature and layer thickness, the fact that the sandpaper is not clogged will indicate that the product is ready to proceed.

Plaster and cement morter:
- Apply suitable fixer before puttying (see family 6): Emulsion Fijadora, Fijamont, Fijalite.
- Test PLASMONT AL USO MULTIUSO suitability on surface.
- Wait till complete drying of product (30 days).
- Remove off any efflorescences and neutralize alkaline surfaces.
- Extremely polished surfaces should be sandpapered to open pores.
- Remove off any foreing products or remains.
- Open any fissures or cracks until obtaining good condition surface. Remove off any resulting dust by brushing and apply PLASMONT AL USO MULTISUO as recommended under Application Systems and Application points.
- For extremely damaged surfaces, use suitable fixer (see family 6) before puttying.
- Recommended maximum thickness per coat should always be observed.

Wood:
- Test PLASMONT AL USO MULTIUSO suitability on surface.
- Extremely polished surfaces should be sandpapered to open pores.
- Remove off any foreing products or remains.
- Open any fissures or cracks until obtaining good condition surface. Remove off any resulting dust by brushing and apply PLASMONT AL USO MULTIUSO as recommended under Application Systems and Application points.
- Recommended maximum thickness per coat should always be observed.
- Only apply on wood in good condition, with no trace of resine exudates, dry and free of dust and grease, with less than 20% moisture level.
- Old wood should be previously sandpapered and dust-free.