MONTOTHERM MORTERO ACRILICO 70

- Shake the product until it is evenly mixed.
- It is necessary to prepare the surface with MONTO thêrm Primer in the same colour to avoid excessive absorption and even
out the colour.
- The product comes ready to use, although it may be slightly diluted before application.
- It is usually spread with a metal trowel, preferably made of stainless steel. It may also be applied using appropriate spray
equipment such as adequately sized drip paint guns with tungsten carbonyl nozzles for coarse, abrasive particles.
- Once applied to the trowel or sprayed, different decorative effects may be achieved, using friction against the surface, with a
damp and clean plastic, steel or wooden trowel.
- This is carried out once a short space of time has passed, which will vary depending on the temperature and humidity (0 to
15 minutes).
- By sticking adhesive paper tape before the application and removing it before the product completely dries, other decorative
effects can be achieved. In this way we can 'cut off' the areas where the product is applied and combine different colours and
shapes.
- Do not apply at temperatures below 5 ºC or above 30 ºC.
-If the Mortar is used as a finishing layer without a thermal insulation system on the outside, it will necessarily be applied over MONTO thêrm Primer, with the performance indicated in FT.

MONTO thêrm system reinforcement layer primed with MONTO thêrm Primer:
1. Wait until the MONTO thêrm Primer coat has fully dried.
2. Clean the surface of any substances that may reduce adhesion.