MONTOTHERM MORTERO SILOXANO RAYADO

-Shake product until perfectly homogenized.
-In order to avoid excessive surface absorption, prepare surface with  Montokril Liso in same colour.
-Ready to use product. Allows being slightly dilluted.
-This product is usually applied by stainless steel metallic trowel, however, it also may be applied by suitable projection equipment such as specific spray gun with pressure pot provided with suitable size of tugstence carbide nozzles  to permit thick particles or approximately 4mm size to go through.
-After application  by metallic trowel, an outstanding pattern may be obtained by rubbing surface with a clean and wet wooden trowel.  This is done after a short period of time which may vary depending on humidity and temperature conditions (between 0 and 15 minutes).
-Spectacular effect finishes may be obtained by placing adhesive tapes previous application of product and removing them off before product dries.  This technique allows the combination of patterns and colours.
-This product should never be appliedat temperatures below 5º C.
- If the Mortar is used as a finishing layer without a thermal insulation system on the outside, it will necessarily be applied over MONTO thêrm Primer, with the performance indicated in FT.
- Do not wash until after 25-30 days.

MONTO thêrm system reinforcement layer primed with MONTO thêrm Primer:
1. Wait until the MONTO thêrm Primer coat has fully dried.
2. Clean the surface of any substances that may reduce adhesion.