Product ready to use in one coat. Very easy to apply, it allows different effects to be obtained and shades coloured and blurred with white tones of maximum elegance. Manual stirring: Colour the product just before application (once coloured it may destabilize in about one week).

1. Anchor the base with Fondo Muros Mediterraneos.
2. Mix the product with the tint by hand when ready to use.
If you have two separate batches of the same product and colour, it is recommended that you mix them together before use to prevent potential variations in the size of the white floccule.
3. Once the chosen colour is perfectly blended, apply one coat of Muros Mediterráneo Nuovo Capri with a flat paint brush using cross strokes, as uniformly as possible.
4. Leave to dry slightly so that it penetrates the base and acquires consistency.
5. Then spread using a flexible plastic trowel, applying even pressure in the same or a different direction, until the desired effect is achieved. This will break up the thick particles that are not yet dry, which will produce a white shaded effect. This will highlight and combine with the already hardened coloured base.
6. Once the colour has been added to the product, it should not be stored for more than 1 week.

Mortar of cement and plaster:
1. Hope until forged total (30 days minimum in cement, not to exceed 20).
2. Clean the support of possible defects by means of abrasive spurt, as well as to neutralize the alkaline surfaces.
3. In excessively polished surfaces, you must sandpaper to open the pore.
4. Fix the weak supports with suitable locking device (FIJADORA emulsion or FIJAMONT).
5. Clean rest of products on support and/or remainders.
6. Fill the defects of the support (to see in family Putties the lines corresponding in dust and prepared putties to make a suitable election).
7. Once the base is prepared, anchor with L-500 coating, or Fondo Muros Mediterraneos. Due to its transpiration properties and texture, this base is ideal for finishes using Muros Mediterráneos Nuovo Capri.

Plaster:
1. Wait for until well dry (max, 20% humidity).
2. Eliminate rest of products and/or remainders.
3. Eliminate defects.
- Regulate the absorptions of the surface by means of primer.
- In surfaces excessively polished to sandpaper to open the pore.
- Fix the weak supports by means of suitable locking device (To see family 6).
- Fill with putty to eliminate the defects of the support (to see in family the lines corresponding - putties -to make a suitable election).
- Deal with MONTOLIMP the supports with mould.
One to see the support in conditions, to cast anchor with Fondo Muros Mediterranean or L-500 coating.

Wood :
Prepare and to seal with SELLADORA SELLALUX.
Once dry, apply FONDO MUROS MEDITERRANEAN OR MONTOKRIL L-500.