Latest generation 100% matt acrylic paint. Specially formulated to stand over the time: resists stains (oil, grease, wine...) and scratches. It can be rubbed without shiny spots. Maximum washability in matt paint. High coverage and performance; Tixoless technology (zero splattering); Multi-adhesive; Scented, immediately inhabits spaces. With anti-mould preservative.

- Remove the product until perfectly homogeneous.
- Apply on clean and dry surfaces, removing dirt with soapy water. In the case of extreme dirt, it is advisable to use degreasing agents or cleaning detergents.
- Apply in accordance with requirements marked in the attached application table.
- Do not apply the product at temperatures below 5º nor on surfaces exposed to strong sunshine.
- Maintain good ventilation conditions during the drying time.
- Do not apply whilst the relative humidity is above 80%.
- For a perfect finish we recommend applying with a spray gun, but if you do use a roller it should be one designed for varnishing.
- Do not wash for the first 24 days.
- Clean tools with water immediately after use.
- Never apply it outdoors if there is an imminent risk of rain, and avoid excessively wet days.
- For spraying with Airless equipment, use 15 to 23 inch nozzles, pressure ? 150 bar.

Reaction time for spot cleaning:

Stain type 5min 2h 24h
Wine OK NO OK NO OK
Coffe OK NO OK NO OK
Tomatoes OK OK OK
Marker pen OK OK OK
Ink OK OK OK
Wax OK OK OK
Fluorescent OK NO OK NO OK
Pencil OK OK OK
Colored pencil OK OK OK

The resistance to stains and the times set for washing them may vary depending on the color of the paint and the type and particular nature of the aggressions suffered. Not valid for permanent markers.

Cement and concrete mortars:
1. Wait until fully set (min. 30 days).
2. Clean any efflorescence with a jet washer.
3. Neutralize alkaline surfaces.
4. Sand polished surfaces to create a rougher surface.
5. Clean the surface to remove foreign products.
6. Set crumbly substrates with Fixer Emulsion or Fijamont.
7. Fill in defects in the substrate (see family 6)

Plaster, plaster-covered brick:
1. Wait until it is completely dry (max. 20% humidity).
2. Clean the surface to remove foreign products.
3. Clean any efflorescence with a jet washer.
4. Regulate surface absorption with sealer, fixer, or a diluted coat of the same product
5. Sand polished surfaces to create a rougher surface
6. Set crumbly substrates with Fixer Emulsion or Fijamont.
7. Fill in defects in the substrate (see family 6)

Plasterboard partition walls:
1. Carry out a general sanding of the joints and putty fixing areas.
2. Then, clean them to ensure the substrate is free of dust, grease and other contaminants.
3. For application on coloured boards that tend to generate stains, apply Montoplac Stain-Resistant Sealer.