Elastic coating for the protection and waterproofing of horizontal surfaces. Photoreticulable Transitable with limited traffic. Good adhesion, high resistance to alkalinity and extreme temperatures. Anti-leak. For higher protection, the use of mesh is essential. On alkaline or cementitious surfaces, always anchor with Fijamont.

- Clean the surface, getting rid of any dirt, moss, mildew, etc. and wash with clean, uncontaminated water.
- Stir the product until perfectly blended.
- Do not apply the product at temperatures below 5 ºC or above 35 ºC. Do not apply if there is a risk of imminent rain and make sure the base is completely dry. The temperature of the base should be above 5 °C to prevent it from freezing. Apply the product when the temperature is 3ºC above the dew point.

Cement mortars:
- Do not begin the treatment before having checked that the cement base is completely dry. The hygrometer-measured humidity value must never be above 4%.
- Apply Fijamont as necessary, properly diluted and in sufficient quantity to completely seal the base and prevent alkalinity from reaching the Tejamont Top Cover. It is always highly recommendable to then apply a first coat of Primer Impermeabilización to improve adhesion and facilitate the incorporation of the fibreglass grid. Apply a coat of Tejamont Top Cover after 4-6 hours. Apply a second coat of Tejamont Top Cover after 24 hours, incorporating the fibreglass grid mesh and applying more Tejamont Top Cover until it is completely covered. Let it dry for 24 hours. Apply a third coat of Tejamont Top Cover.

Brick, matt fine tiles, asphalt cloth and polyurethane foam:
- Proceed as for cement mortar, with no need to apply Fijamont
- Once the surface is repaired it is highly recommendable to always apply a first coat of Primer Impermeabilizante, to facilitate the incorporation of the fibreglass.

Asphalt cloth:
-It is advisable to prime the surface, once cleaned, with Imprimación Epoxi Suelos.

Cement mortar:
1. Wait until completely set (minimum 30 days).
2. Clean the base to remove any residues, loose or foreign products.
3. Eliminate any potential efflorescence from the base with an abrasive jet and neutralise alkaline surfaces. Sand down highly polished surfaces to open up the mortar. Fill with Plasmont Fibra Elástico if required.
4. Before proceeding to prepare it, the base must be totally dry - the hygrometer-measured humidity value must never be above 10%.
5. Apply Fijamont to all the cement mortar surface so that it does not come into contact with Tejamont Top Cover.
6. Anchor with Primer Impermeabilización for optimum adhesion of the System.
7. Apply Tejamont Top Cover and fibreglass grid according to the System section.

Catalan tile or matt porous brick:
1. Idem for on cement mortar, with no need to apply Fijamont.

Polyurethane foam and asphalt cloth:
1. Verify adhesion and and if necessary, anchor with Imprimación Epoxi Suelos.
2. Always treat mildewed surfaces with Montolimp.
3. Idem that on cement mortars.

Recommended minimum consumption: Three coats of 0.
50 l/m2. Include fibreglass grid on the second coat.