Cementitious finishing coating for floors; it is part of the MicroCement system. Its function is to obtain a decorative finish.

- Environmental conditions:

- It is recommended, especially indoors, that there be air renewal.
- Ambient temperature: 5-35 ºC - RH ? 75%.
- This range must be maintained during the first 72 hours.
- Substrate temperature ? 8ºC and 3ºC above the dew point. Essential to avoid condensation.
- Variations in ambient temperature during the application process also alter the setting and drying times of the material. Below 20ºC, the drying time increases.

- Preparation of the mixture:

- In the empty bucket that is included in the pack, pour the MICROCEMENT RESIN with color and previously shaken. The proportion is 13 Kg Part A (Powder) + 5 Kg Part B (Resin with color).
- Sprinkle little by little and beat by mechanical stirring until obtaining a homogeneous paste free of lumps.

-Application conditions:

- Apply with a steel trowel with rounded edges, in thin layers, 2 to 3 layers depending on the application, leaving 2 to 3 hours between coats, until the desired decorative effect is achieved.
- On tiles use MICROCEMENT BASE and fiberglass mesh.
- Consumption calculated on MICROCEMENT BASE:
- Per coat: 0.
8 Kg / m2 (approx 0.
4 mm thick). (13 A + 5 B for 10 m2)
- Total: 1.
6 - 2.
4 Kg / m2 (0.
8 - 1.
2 mm thick). (13 A + 5 B for 4 - 8 m2)
- Maximum thickness of the entire BASE + WALLS system (1 to 3 mm)

- End use:

- After 24 hours, sand the entire surface well, with a fine sandpaper with a grain greater than 180.
- We perfectly clean the dust generated, vacuuming.
- Continue with the Microcement SEALER.
- Optimal mechanical properties are reached after 28 days.
- The MICROCEMENT Ó deco system is not recommended for liquid containment supports, such as swimming pools, tanks or bathtubs.

Over Microcement Base:

- Sand with 120/180 clean and remove the dust well, preferably by vacuuming.