Lime (mineral) wall coating. Highly Breathable. Petrifies. For decorative effects, marble imitations, spatulate, etc…

- Indoor use:

On plaster/ gypsum or cement bases in perfect condition. Do not apply stucco directly, wet the surface with clean water until damp.
It is advisable to add a small amount of lime to this water to help the stucco to adhere to the base (diluting a small amount of stucco in the water will also do the job)
On rustic bases, such as lime mortar walls, simply dampen with water.
Prime unsound bases with fixative emulsion
If the bases are painted, it is advisable to remove as much of the paint as possible to optimise the adhesion of the stucco.
In humid rooms such as bathrooms it is advisable to protect the Grasello with two coats of Impersil Aqua and in areas with condensation or direct contact with water, protect with two coats of Fijamont Aqua (4:
1) and another two coats of Impersil Aqua 2 weeks after the stucco is applied, making sure it is completely dry. The stucco should not come into contact with steam or water until it is completely dry (15 days).

- Outdoor use:
On plaster/ gypsum or cement bases in perfect condition. Do not apply stucco directly, wet the surface with clean water until damp.
It is advisable to add a small amount of lime to this water to help the stucco to adhere to the base (diluting a small amount of stucco in the water will also do the job)
On rustic bases, such as lime mortar walls, simply dampen with water.
Prime unsound bases with fixative emulsion
If the bases are painted, it is advisable to remove as much of the paint as possible to optimise the adhesion of the stucco.
Do not apply when raining or when there is a risk of imminent rainfall. The stucco needs to dry for a minimum of 48 to 72 hours before coming into contact with water. After 2 weeks, once you have verified that the product is completely dry, it can be protected with Fijamont Aqua (4:
1) or Impersil Aqua.
3 to 4 months after applying the protector it is recommended that you apply another coat to reinforce the protection.

Cement morter:
1 -Wait till complete drying of product (30 days minimum).
2 -Remove off any efflorescences by abrassive jet
3 -Neutralize alkaline surfaces.
4 -Extremely polished surfaces should be sandpapered.
5. Clean rest of products on support and/or remainders.
6. Fix the weak supports with suitable locking device (FIJADORA emulsion or FIJAMONT).
7. Fill the defects of the support (to see family 6).

Plaster:
1. Wait for until well dry (max, 20% humidity).
2. Eliminate rest of products and/or remainders.
3. Clean the support of possible defects by means of abrasive spurt.
4. Regulate the absorptions of the surface by means of primer.
5. In surfaces excessively polished to sandpaper
6. Fix the weak supports with EMULSION FIJADORA or FIJAMONT
7. Fill with putty to eliminate the defects of the support (to see familly 6).