Aliphatic enamel highly resistant to impact and abrasion. Elastic. Does not yellow. Crystalline texture.

Compose colour following the Sistema Montomix instructions in the Acripol part.
When you are ready to paint, add the Acripol catalyst. Stir the product until perfectly blended.
Apply to clean dry substrates, removing any waste matter using degreasers or detergents and clean water.
Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
Ensure good ventilation whilst the product is drying. Do not apply with relative moisture levels over 80%.
Given the broad spectrum of bases, for direct applications on problematic surfaces, it is recommended that you first carry out adhesion tests. If false adhesion is detected, prime as indicated in the attached table.
As a preventive measure, prime using the products indicated in the table attached.
On tiles and ceramic surfaces, carry out adhesion tests. It is recommended that the pore be opened using hydrochloric acid.

In general:
Apply to repaired, smooth surfaces free from grease and foreign materials.

Particularly remove grease and foreign materials. Remove dust
In Particular:
Iron and derivatives:
- Remove any rust and treat with recommended primers following the technical specifications given.
To decorate the base it must be free from foreign products and/or waste matter and should be dry and free from grease and dust. If there are signs of rust, the rust should be removed using a plane or other mechanical means. Oxifín may also be used (see technical specifications).
New wood:
-The base must be free from foreign products and/or waste matter.
-Apply to woods with a moisture content of less than 20%.
-Apply to wood which is healthy, dry and free from grease and dust.
-Sand down to remove any traces of glue in joints and milling defects.
-If the wood shows signs of ageing, it should first be sanded down, primed and any dust removed by brushing or any other mechanical means.
-In this instance the most suitable primer is GAMA MONTOPOL.
Plaster work (plaster/gypsum, cement and derivatives):
- Treat these mediums in the usual way, removing saltpetre, excess moisture and efflorescence.
- Remove foreign products and/or waste matter.