Multi-adhesive enamel. Odourless. Excellent anchorage, even directly on some galvanised surfaces. Does not yellow. Breathable.

-Stir well .
-Only apply on clean surfaces, clean off any dirt by using clean water and detergents.
-Follow guidelines as shown in table below.
-Should it be applied on specific metals, different types of galvanic or difficult surfaces, we recommend priming with Ecoprimer first.
-New wood should be previously primed with Montoxyl Fondo, to prevent surface from fungus and harmul bacteries.
-Do not apply product at high temperatures or overheated surfaces exposed to sunshine.
-Keep room well ventilated while product is drying.
-Do not apply when moisture contents it over 80%.

Construction (plaster, cement etc):
1 -Surface should be completely dry.
2 -Remove off any efflorescences and neutralize alkaline surfaces.
Remove off peelings and dirtiness. Apply suitable plaster.
3 -Mildewed surfaces should be treated with Montolimp (fungicide).


New wood:
1 -Surface should be free of any foreign products or remains.
Apply on wood with less than 20% humidity content.
Apply on wood in good condition, dry and free of grease and dust.
2 -Sandpaper and eliminate any remains in joints and mechanical faults.
-Old wood should be previously sandpapered and primed. Remove any dust by brushing off or using any other mechanical system.
3 -In this case, we recommend priming with Ecoprimer or Selladora Sellalux (fam 5)

Iron and metals :
1 - For surface protection prior to decoration, apply a suitable primer (See familily 9) following its corresponding data sheet guidelines.
-Prior to decoration, surface should be free of any dirtiness, grease, dust and completely dry. Should it show any rust, apply our Oxifin or remove it by brushing off or any other mechanical system.
2 -Follow by applying suitable primer ( fam 6)