Multi-adhesive enamel. Odourless. Excellent anchorage, even directly on some galvanised surfaces. Does not yellow. Breathable.

Stir the product until perfectly blended.
- Apply to clean, dry substrates, removing dirt with degreasing agents or detergents and clean water.
- Apply, following the rules set out in the attached application table.
- Prior to application on new woods, prime with Montoxyl Fondo if you require preventive protection against fungus and bacteria.
- Do not apply the product at temperatures below 5ºC, or to surfaces exposed to strong sunlight.
- Do not apply at relative humidity in excess of 80%.

Plaster, cement and derivatives:
1. Wait until fully hardened.
2. Clear possible efflorescence from the base and neutralise alkaline surfaces. Use a suitable filler to eliminate defects in the base.
3. Treat mouldy bases with Montolimp.

New woods:
1. Apply to woods with a moisture content of less than 20%. Healthy, dry wood, well cleaned of dust and grease.
2. If the wood shows signs of ageing, it should first be sanded down, primed and any dust/powder removed through brushing or any other mechanical means.
3. Before application, prime using a suitable product, see Family 5 wood treatments.

Iron and derivatives:
1. Apply to dry bases, well cleaned of dust and grease. If these show signs of oxidation, rust must be removed through brushing or any other mechanical means. Oxifin is also suitable.
2. When this is done, treat using a suitable primer prior to application, see Family 6.

Galvanised and light metals:
1.
- Remove all grease and check the adhesion.
2.
- Priming with Montoprimer Total Acqua is recommended where necessary.