Multi-adhesive enamel with metallic effect. Odourless. Excellent anchorage, even directly on some galvanised surfaces. Does not yellow. Breathable.

-Stir product throughly.
-Ensure substrate is in good condition and free from dust, grease and any other contaminants. Clean off any dirt by using clean water and detergents.
-Follow guidelines as shown in table below.
-Should it be applied on specific metals, different types of galvanized or difficult surfaces, we recommend priming (See familily 6) following its corresponding data sheet guidelines.
- Prime previously, on new wood, with Montoxyl Fondo if a preventive protection against fungi or bacteria is desired.
-Avoid painting when the temperature is below 5 degrees Celsius or overheated surfaces exposed to sunshine.
-Always work in a well ventilated area
-Relative humidity should be below 80%.

Construction (plaster, cement and by-products).
-Ensure that surface is completely cured and dry
-Remove off any efflorescences and neutralize alkaline surfaces. If substrate is damaged, plaster and sand before painting it.
-Mildewed surfaces should be treated with Montolimp.

New wood:
-Wood moisture content should be below 20%. Ensure substrate is in good condition and free from dust, grease and any other contaminants.
-If wood looks old, it should be previously sandpapered and primed. Remove any dust by brushing off or using any other mechanical system.
-Unpainted surfaces should be properly primed (See familily 5) following its corresponding data sheet guidelines.

Iron and by-products:
- Ensure substrate is in good condition and free from dust, grease and any other contaminants. Should it show any rust, apply our Oxifin or remove it by brushing off or any other mechanical system.
-Unpainted surfaces should be properly primed (See familily 6) following its corresponding data sheet guidelines.