Plastic paint with an excellent balance between covering power, gloss and resistance. Low splatter.

Shake product until perfectly homogenized.
This product should be dilluted depending on surface conditon and porosity level.
Finish with one or more coats slighlty dilluted until surface is totally covered.
Do not apply product at temperatures below 5ºC or any surfaces which have been exposed to sunshine.
- Do not wash for the first 24 days.
- Never apply it outdoors if there is an imminent risk of rain, and avoid excessively wet days.
- Clean tools with water immediately after use.
- For spraying with Airless equipment, use 15 to 23 inch nozzles, pressure ? 150 bar.

Cement morter:
-Wait till complete drying of product (30 days minimum).
-Remove off any efflorescences by abrasive jet and neutralize alkaline surfaces.
-Extremely polished surfaces should be sanpapered to open pores.
-Remove off any foreing products or remains.
-Use Emulsión Fijadora like primer to prevent ?sheen?.
-Cover surface imperfections with Plastmont Exteriores (See Family 6 to help you choose the most suitable product to prepare surfaces).
-Plaster:
-Wait till complete drying of product (20% max. Moisture level).
-Remove off any foreign product or product remains.
-Remove off any efflorescences.
-Use a sealant or matt paste to regulate surface absorption.
-Extremely polished surfaces should be sandpapered to open pore.
-Very damaged surfaces should be fixed with suitable product (See Family 6.
)
-Cover surface imperfections with plaster or putty (See Family 6 to help you choose the most suitable product to prepare surfaces).
-Use Emulsión Fijadora like primer to prevent ?sheen?.

Plasterboard partition walls:
1. Carry out a general sanding of the joints and putty fixing areas.
2. Then, clean them to ensure the substrate is free of dust, grease and other contaminants.
3. For application on coloured boards that tend to generate stains, apply Montoplac Stain-Resistant Sealer.