Plastic paint with an excellent balance between covering power, performance and resistance. Very easy to apply. No dripping. 0 splatter (tixoless technology).

- Remove the product until perfectly homogeneous.
- Apply on clean and dry surfaces, removing dirt with soapy water. In the case of extreme dirt, it is advisable to use degreasing agents or cleaning detergents.
- Apply in accordance with requirements marked in the attached application table.
- Do not apply the product at temperatures below 5º nor on surfaces exposed to strong sunshine.
- Maintain good ventilation conditions during the drying time.
- Do not apply whilst the relative humidity is above 80%.
- For a perfect finish we recommend applying with a spray gun, but if you do use a roller it should be one designed for varnishing.
- Do not wash for the first 24 days.
- Clean tools with water immediately after use.
- Never apply it outdoors if there is an imminent risk of rain, and avoid excessively wet days.
- For spraying with Airless equipment, use 15 to 23 inch nozzles, pressure ? 150 bar.

Cement morter:
-Wait till complete drying of product (30 days minimum).
-Remove off any efflorescences by abrasive jet and neutralize alkaline surfaces.
-Extremely polished surfaces should be sanpapered to open pores.
-Remove off any foreing products or remains.
-Bad condition surfaces should be anchored properly (see family 6).
-Cover surface imperfections with Plastmont Exteriores (See Family 6 to help you choose the most suitable product to prepare surfaces).
-Plaster:
-Wait till complete drying of product (20% max. Moisture level).
-Remove off any foreign product or product remains.
-Remove off any efflorescences.
-Use a sealant or matt paste to regulate surface absorption.
-Extremely polished surfaces should be sandpapered to open pore.
-Very damaged surfaces should be fixed with suitable product (See Family 6.
)
-Cover surface imperfections with plaster or putty (See Family 6 to help you choose the most suitable product to prepare surfaces).

Gypsum plasterboard partition walls:
1. Carry out a general sanding of the joints and putty fixing areas.
2. Subsequently clean to ensure that the surface is free of dust, grease and other contaminants.
3. For application on coloured boards that tend to generate stains, apply Monoplac Stain-Resistant Sealer.