Plastic paint with good coverage, whiteness and rub resistance. For outdoor use in mild climates.

Shake product until perfectly homogenized.
First coat should be dilluted depending on surface conditon and porosity level.
Finish with one or more coats slighlty dilluted until surface is totally covered.
Do not apply product at temperatures below 5º C or any surfaces which have been exposed to sunshine.
- Do not wash for the first 24 days.
- Never apply it outdoors if there is an imminent risk of rain, and avoid excessively wet days.
- Clean tools with water immediately after use.
- For spraying with Airless equipment, use 15 to 23 inch nozzles, pressure ? 150 bar.

Masonry mortar:
1. Wait for until forged total and drying of the surface (30 days minimum).
2. Clean the support of possible efflorescences by means of abrasive spurt
3. To neutralize alkaline surfaces.
4. In surfaces excessively polished to sandpaper to open the pore
5 . Clean the strange product on support.
6. the suitable primer if necessary is Emulsion Fijadora or Fijamont.
7. Fill with powdered filler or prepared putties, (to see family 6)

Plaster:
1. Wait for until well dry (max, 20% humidity).
2. Eliminate rest of products and/or remainders.
3. Eliminate defects.
4 - Regulate the absorptions of the surface by means of primer.
5 - In surfaces excessively polished to sandpaper to open the pore.
6 - Fix the weak supports by means of suitable locking device (To see family 6).
7 - Fill with putty to eliminate the defects of the support (to see in family 6 - putties).

Plasterboard partition walls:
1. Carry out a general sanding of the joints and putty fixing areas.
2. Then, clean them to ensure the substrate is free of dust, grease and other contaminants.
3. For application on coloured boards that tend to generate stains, apply Monoplac Stain-Resistant Sealer.