Universal water-based, multi-adhesive, single-component primer for most substrates. Antioxidant and fast drying. Repaintable with plastics, enamels, polyurethanes, epoxies…

Stir and dilute, if necessary, until perfectly blended.
Apply in accordance with the instructions given in the attached application table.
Do not apply the product at high temperatures or on surfaces exposed to strong sunlight.
Do not apply at relative humidity in excess of 80% or at temperatures below 5ºC or above 35ºC.
Maintain good ventilation conditions while drying.
Given the variety of bases and substrates, it is advisable to carry out previous tests to ensure that the product behaves as is required on surfaces with difficult, problematic or doubtful adhesion.
- To repaint with water-based products, we have Montoprimer Total .
- To repaint with products differing from the recommended it is necessary to carry out tests in remote areas or refer to our Technical Department.

The surface must be free of foreign products, rust and/or residues
Apply on properly degreased, dust-free and dry surfaces. The surface must be sanitised before applying the product.
The quality of the primer and the paint is as important as the quality of the pre-treatment.
Afterwards, apply Montoprimer Total Acqua and then the intermediate paint and the finish coating.
A light sanding can improve adhesion.

Metal: Deoxidise it with a light sanding, degrease and remove the dust. Apply the product in the indicated density.

PVC and methacrylate: Clean, sand lightly and remove dust. Apply the product in the indicated density. Due to the diversity of surfaces and substrates, regarding surfaces without good adhesion, as in this case, it is advisable to conduct previous tests to verify the correct performance of the product.

Wood: Remove any dirt, resin and secretions from the surface, sand lightly in the direction of the grains, remove the dust and apply the product in the indicated density.
In the case of outdoor woods, apply Anticarcoma Klearxyl DI, a product that provides protection against xylophages.

Glass and tiles: Clean, tint and remove the dust. Apply the product in the indicated density. Due to the diversity of surfaces and substrates, regarding surfaces without good adhesion, as in this case, it is advisable to conduct previous tests to verify the correct performance of the product.