Inicio / Preparaciones, fondos e impr. / Suelos (imprimaciones) / Water based epoxy primer, universal adhesion promoter on low porous substrates, on floors, walls and non-ferrous metals. Repaintable with epoxy, polyurethane and acrylic paints. High performance.

    • Water based epoxy primer, universal adhesion promoter on low porous substrates, on floors, walls and non-ferrous metals. Repaintable with epoxy, polyurethane and acrylic paints. High performance.

    Transparent, water-based product for applying to a wide variety of surfaces, made from modified polymide and expoxy resin, designed to act as a bridge between surfaces with adhesion problems and the rest of the finishing products.
    Rendimiento
    7 - 14 m²/L
    Tiempo de secado
    2-4h
    Me interesa este producto
    Add the water to part A and stir the product until perfectly blended.
    Add the catalyst and stir again until perfectly blended.
    Apply to clean dry substrates.
    Pavement moisture: maximum 8% measured at a depth of 2 cm
    Do not apply at temperatures below 10 ºC.
    Do not apply at high temperatures or to surfaces exposed to strong sunlight. The ideal temperature is between 15 and 25 ºC.
    The ideal relative moisture level is between 30 and 70%.
    Good air circulation and renewal is recommended.
    FLOORS: It is essential that the product is prepared correctly.
    1. Wait until it is completely set (minimum 30 days): Remove efflorescence.
    2. The floor must be clean, dry and if necessary levelled.
    3. Any grease and oil must be fully removed.
    4. Sandblasting or bush hammering is the best solution, although in some cases a caustic soda solution diluted to 15-20%, followed by rinsing and neutralisation with hydrochloric acid is sufficient. The ideal porosity of the floor can also be achieved through sandblasting or bush hammering.
    5. On floors which are moderately porous, a hydrochloric acid based chemical treatment may be sufficient followed by thorough rinsing with water.
    6. If you have any doubts, before applying a treatment consult our Technical Department, as it may not always be sufficient. On asphalted surfaces, never apply at high temperatures, remove foreign products and check that no plastifiers have migrated.

    Descargas

    ¡Me interesa
    este producto!

    Confirma el producto y tus datos de contacto para que podamos informarte y asesorarte de forma personalizada

    Stock siempre disponible

    Gestión automatizada de las ubicaciones y las existencias de los productos.

    Pedidos perfectos.

    Los pedidos son preparados mediante radiofrecuencia reduciendo los errores en su preparación a 0.

    Control de almacén.

    Ubicación automática de los productos en el almacén mediantes transelevador.

    Carga rápida.

    Ocho muelles de carga para camiones de 24 toneladas.

    Transporte propio.

    Flota propia de camiones de reparto preparados para transporte ADR.

    Nos tienes cerca.

    Cadena de tiendas propia y suministro a puntos de venta en toda España.

    Calculadora de litros

    El número de manos depende de la superficie a aplicar el producto.

    Para pintar m2 de superficie con mano(s) de pintura necesitas:

    de Water based epoxy primer, universal adhesion promoter on low porous substrates, on floors, walls and non-ferrous metals. Repaintable with epoxy, polyurethane and acrylic paints. High performance.